Local contractor in 22153

An unsafe outlet near water was identified during the inspection, and a new 20 amp GFCI receptacle was installed in its place after assessing the wiring. We also addressed a 240 V dryer plug that lacked a cover plate, eliminating the potential shock hazard. Additionally, we corrected the reverse polarity issue with the upstairs master bathroom outlet and resolved problems with the attic fan and exhaust fan, ensuring everything is now functioning as it should.

Insufficient power outlets in the garage limited the availability of electrical equipment. We resolved this by verifying the foyer circuit's capacity, extending wiring to install two new GFCI-protected receptacles, and ensuring compliance with electrical codes. After securing the wiring and testing functionality, the garage now has convenient and safe power sources for general use.

An outdated main load center posed a safety risk, so we replaced it with a new Square D 30 Space, 60-Circuit, 200-Amp panel. We ensured compliance with the National Electrical Code and Fairfax County standards, executing a thorough installation, including grounding upgrades and whole-home surge protection. The system was tested for functionality post-installation.

We identified multiple safety concerns during the inspection, including an improperly placed 15-amp breaker and lack of GFCI protection for kitchen outlets. We relocated the breaker and installed new GFCI receptacles in the kitchen and garage. Additionally, we addressed code violations in the basement by roughing in two new 120V outlets for the modified rooms, ensuring compliance with electrical standards.

We addressed issues with GFCI circuit breakers that had caused power loss in multiple areas, including the main bathroom hallway, a downstairs bathroom, the garage, and an exterior outlet. After troubleshooting, we discovered a connection problem in the exterior outlet and noted that 15-amp wiring was improperly linked to a 20-amp breaker. After terminating the affected outlets and installing a new breaker, power was successfully restored to all areas.

The existing light fixtures in the basement laundry room were malfunctioning and needed a solution. We rewired them to operate on a three-way switch setup. New switches were installed near both doors, ensuring optimal access. After routing the necessary wiring and installing the fixtures, we tested everything to confirm proper functionality. Any drywall damage from the install should be addressed by a professional.

The bathroom fan was not functioning, prompting a call for assistance. We diagnosed the problem, found the problem, and made the repair, ensuring the fan was restored to optimal performance, enhancing ventilation in the space.

Experiencing a whole home power outage, we immediately dispatched our expert electricians to diagnose the issue. Through a thorough inspection of the electrical system, we identified and repaired a faulty circuit breaker, restoring power efficiently and ensuring the home’s electrical systems are fully functional and safe.

A flickering light was causing concern, so we conducted a thorough diagnosis to identify the issue. We traced the problem to a faulty connection and promptly repaired it, restoring normal functionality and providing peace of mind.

A malfunctioning light switch in the main level bathroom caused a power outage throughout the home. We evaluated the wiring for issues before installing two new light switches. After installation, we thoroughly tested the switches to ensure that power was restored to all areas of the home.

An outdated electrical panel can lead to safety concerns and insufficient power supply. We replaced the existing main load center with a new Square D 200-Amp panel, ensuring compliance with all local codes. We also installed a generator inlet connection for emergency power, allowing the homeowner to maintain control during outages. All circuits were tested for functionality, completing the upgrade effectively.

Persistent flickering lights were causing concern in the home. We conducted a thorough inspection, identifying loose connections and an overloaded circuit. After securing the connections and balancing the load, the lights regained their stability, restoring peace of mind and consistent lighting throughout the space.